Arturia Forums

Harware Legacy versions => Origin => General Discussion on Origin => Topic started by: Syndromeda on February 11, 2011, 11:51:47 am

Title: 1.3 bug?
Post by: Syndromeda on February 11, 2011, 11:51:47 am

When in Jupiter-8 template, in the "ASSIGN" page, put HOLD on, save it, select another preset, go back to the saved Jup-8 preset and HOLD is still on but is not active anymore. When putting off the Origin and putting back on, the HOLD even is not saved, it's not assigned anymore.
Regards,
Danny

Title: Re: 1.3 bug?
Post by: Syndromeda on February 18, 2011, 08:33:49 am

So....nobody can reproduce this or what????

Title: Re: 1.3 bug?
Post by: Niccolo on February 18, 2011, 10:31:02 am

Hi, yes it can be reproduced easily! Thank you for that report.

In fact, this is partly normal: the HOLD state of a program is not a normal parameter because it is never saved: neither in an Origin module patch nor in a Jupiter8 template. So the expected behavior would be that be that after loading again the program, both the Hold hardware LED and the Hold LED in the interface of the template are off.

After you do a "Save As", the preset is reloaded, that's why the hold turns off. But the bug is that in this case the LED in the template interface is still on. Anyway you can reset it to a correct state by pressing twice the Hold button.