Arturia Forums
V Collection - Legacy versions => ARP2600 V => ARP2600 V Technical Issues => Topic started by: SteveC on November 24, 2009, 10:36:29 am
-
I do have problems with the ARP 2600 and the Mg Modular since I did the upgrade to Snow Leopard + Logic 9.
If I start any session with an ARP 2600 the session crashes. If I start a fresh session with no plugs and try to load ARP 2600 it crashes.
I do run a Mac Intel 8-Core 3 GHz with 16GB Ram
I did all the Updates from the Artruria Update side and still have this problem.
The Plugs are in the right folder:
Mac HD / Libary / Audio / Plug.Ins / Components / ARP2600 V. component
I found another folder:
Mac HD / Libary / Preference / arp2600v ... ambt.dat + save folder
is this correctly installed or do I have to put this folder somewhere else?
I do need help, does someone have the same problem or any solution?
Thanks for comming back to me
STEVE
-
I just searched on the internet and found a demo download that worked for Intel OSX Snow Leopard:
http://mac.softpedia.com/progDownload/ARP-2600-V-Download-53585.html
This is only a trial ... hope that it will accept my Serial Number in 2 weeks :-)
STEVE
-
As I said before, I tried the DEMO Version of the 2600V and it works! It is no full Version and has some Limitations that makes professional work impossible.
I deinstalled the Demo Version of the ARP2600v and tried my original Version again. As I said before I did all this updates also Firmware blahblah ... and it still crashes my Logic. It does also not work as stand alone Version.
What`s going wrong here? The Demo is working on Snow Leopard but the original bought Version does not work????
HELP !!!!
STEVE
-
Perhaps updating your syncrosoft/elicenser might help?
I'm not sure if the demo has to access the copy protection libraries...