Arturia Forums
Hardware Instruments => MicroBrute => MicroBrute Technical Questions - FAQ => Topic started by: Howard on February 05, 2014, 07:26:26 pm
-
I noticed that the gate length isn't correctly proportional to the step size (see connection software). This is a bit annoying, because although e.g. I can get a nice 75% (long) when step is set to 1/4, I can't make the sequence fast enough. Vice versa for the 1/32 setting: even "long" is much too short when the speed is at minimum.
Otherwise loving the Microbrute :-)
-
Bump. OK, if it doesn't annoy anybody else...
-
http://www.arturia.com/evolution/smf/index.php?topic=14393