Arturia Forums
Hardware Instruments => MicroBrute => MicroBrute Technical Questions - FAQ => Topic started by: kaoz on January 03, 2014, 10:55:08 am
-
Hello everybody i`m new to this forum
and sadly i have to start with a tech problem.
Here the facts:
-Microbrute gives no sound out of Headphones (At the moment i can`t check out the lineout)
except directly after turned on. there would be a sound half of a second. fading away directly. this goes for sequncer and keyboard!!! SEquencer is on clock
-Envelope gets signal
- All lights are blinking busy as they did when it was working.
-filter is open wide so no this cant be it either... also envelope is set so there MUST be a signal.
-i did use the arturia power adapter and i live in germany. i did work in fact for a week.
- shortly after firmware update it went dead... but that must not be the reason.
Any suggestions? or do i have to go to the shop and give it back?
-
please try of setup the "basic patch" available in the user manual
-
It sounds like we are having the same problem. I went through the basic patch routine but nothing, all less working properly, envelope filter and lfo seem ok. I get just a clicking sound when I launch the sequencer. I get filter sound If I turn resonance up and cutoff down. I'm fearing the oscillator is dead. I got mine around november 11th and the problem appeared january 18th. And you?