Arturia Forums

Audio => AudioFuse => AudioFuse - General discussions => Topic started by: johnghadimi on March 11, 2023, 09:54:47 pm

Title: Connecting the AudioFuse to an Analog channel strip
Post by: johnghadimi on March 11, 2023, 09:54:47 pm

I've recently acquired an analog channel strip. I wanted to put my Mic through that first and then route the output of the channel strip into AudioFuse to capture it in my DAW. I have two options to output from my strip into AudioFuse: a XLR output or a TRS output.

Which one should I be using?? I'm currently using the XLR but that gets recognized by AudioFuse as a mic input. I'm not sure if that is the right way to go. Would love some advice here. Thank you.

Title: Re: Connecting the AudioFuse to an Analog channel strip
Post by: DrJustice on April 10, 2023, 03:06:36 pm

It depends on your analog channel strip. I'd think it outputs a line level signal. In that case use TRS and select line input on the AudioFuse.

You can read more about the AudioFuse inputs manual chapter "3.3. Inputs and Outputs" - there's a diagram that shows how the path for the XLR and TRS inputs differs.