Arturia Forums
Software Instruments => CMI V => CMI - General Discussions => Topic started by: Jon Donson on December 12, 2021, 11:35:01 pm
-
Just to clarify:
whenever you load a stereo sample into CMI V, only the left channel will be processed.
The right channel will be ignored.
(Fair enough if you want to mimick the original CMI style.)
--
After doublechecking:
not true.
Both channels are processed.
-
Hi,
Stereo samples does'nt show as two waveforms side by side, but both channels should sound.
Have you tried to import a stereo sample with a very clear left and right? You should be able to hear this.
If you change the sample using "convert to synthesis", then there will be differences, if you use the L+R channel setting or not, and thus indicate if you have both the L and the R sound data.
Can't tell if it also depend on the used file.
-
Have you tried to import a stereo sample with a very clear left and right?
Sorry, just tried again. You're right. Just the left channel is shown but both channels are on the output. It's all good.
-
Sorry, just tried again. You're right. Just the left channel is shown but both channels are on the output. It's all good.
All good.
Cheers.