Arturia Forums

Hardware Sequencers => KeyStep Pro => KeyStep Pro - Technical Issues => Topic started by: dancloud on January 25, 2021, 06:10:18 pm

Title: Chains are not saved with Project (Firmware 1.3.7)
Post by: dancloud on January 25, 2021, 06:10:18 pm

Hi,

when I create pattern chains for one or more tracks in a project and save the project, the next time I start up Keystep Pro and load such a project the chains are gone/empty. This happens with FW 1.3.7.

Interestingly, I have two older projects (in project slots 1 and 10) for which the chains were saved successfully and are recalled when the projects are loaded. As far as I recall these projects were created with older FW levels.

I noticed that some other user reported the same problem back in September 2020, but there were no responses at the time.

Any help is appreciated.

Dan

Title: Re: Chains are not saved with Project (Firmware 1.3.7)
Post by: madb on January 26, 2021, 09:49:39 pm

I've run into this too -- it seems that the chains need to be specifically saved to scenes if you want them to persist when the KSP is off. This worked for me, anyway!