Arturia Forums
Software Instruments => Jun-6 V => Jun-6 V - General Discussions => Topic started by: encore1 on December 24, 2020, 02:37:00 am
-
Hello,
I have got a JUNO 106 hardware and I am trying (without success until now) to use it as a MIDi controller instead of my Arturia Keylab 88 as I thought that it would be easier to use with the ppropriate controls mapped on each slider, buttons,etc. but I could not manage yet to make it work.
I have set the MIDi switch to the position III (3) on the juno-106 I have connected the IN/OUT MIDi connectors via my iRig2 MIDi ports and selected the "Generic MIDI controler" from the JUN-6v but when I am moving a slider in the synth to map it to a selected control of the JUN-6V nothing is moving. :-\
The midi channel is set to 1 on the JUNO-106 and ALL in the JUN-6V settings panel.
any suggestions are welcome as I do not understand why it does not work as I can control my JUNO 106 in both ways (from the GUI or from the hardware) without problem (with the same midi setup)via the J-106 librarian application: http://www.jarvik7.net/juno-106/
Thanks in advance for your help.
Cheers, eric
-
I am answering to myself finally... :)
by digging a bit on the web, it appeared that the JUNO 106 is using system exclusive MIDI message instead of CC expected by the ARTURIA JUN-6V.
I have found are some JUNO 106 MIDi implementation information in the following web pages if someone is ineterested:
http://www.hinzen.de/midi/juno-106/howto-02.html
http://erha.se/~ronny/juno2/Roland%20Juno%20MIDI%20System%20Exclusive%20Info.htm
http://www.zikinf.com/manuels/roland-juno-ds61-midi-implementation-en-50123.pdf
=> I will try to do the SYSEZX -> CC conversion using this software:
https://www.youtube.com/watch?v=ri4VC3Z1i0U&list=PLzwHsH6-VZ8Qy_dxsf0LqorjarvnDIFiy&index=16
If someone is interrested, and if I manage to do something working (as it does not seems that easy at a first sigth), I will keep you informed.
Cheers, eric