Arturia Forums

Hardware Sequencers => KeyStep Pro => KeyStep Pro - General Discussions => Topic started by: Toonook on June 08, 2020, 04:34:24 am

Title: KSP + 2nd KSP/BSP loopers sync?
Post by: Toonook on June 08, 2020, 04:34:24 am

Hi all,

I have a KSP on order, and I'm wondering - if you have 2 KSP or a KSP + BSP, is there a way to get the loopers of both to trigger when you use one of them? Or will each only loop the tracks that device is sending out.

Title: Re: KSP + 2nd KSP/BSP loopers sync?
Post by: Terrym on June 08, 2020, 09:14:27 pm

Hi,   I have the KSP and the BSp connected via midi din and i can confirm that when in sync and you have setup the CC for the strips the same. that the Ksp triggers the touch strip on the bsp in sync.

Hope this answers your question.

Title: Re: KSP + 2nd KSP/BSP loopers sync?
Post by: bobbysteels on June 09, 2020, 09:12:42 pm

Quote from: Terrym on June 08, 2020, 09:14:27 pm

Hi,   I have the KSP and the BSp connected via midi din and i can confirm that when in sync and you have setup the CC for the strips the same. that the Ksp triggers the touch strip on the bsp in sync.

Hope this answers your question.

Can you clarify how this is done?  I've set my BSP looper strip to cc #9, which according to the KSP manual is the KSP roller cc.  Any ideas?
**EDIT** - It does work for me.  Thanks

Also as an aside, is there any way to have the touch strip/looper also "loop" arps that are being played?  On my KSP the arpeggios continue while the drums repeat per instructions from touch strip.  Thanks