Arturia Forums
Hardware Sequencers => KeyStep Pro => KeyStep Pro - Technical Issues => Topic started by: agion on April 25, 2020, 09:27:22 pm
-
Hi,
I might have found a bug, or I can't figure out what I'm doing wrong.
1. I created a drum pattern with in bar 16 as Poly.
2. Regreted my design and changed to Mono.
3. Pressed Copy+16
4. Pressed Paste+32
5. Pressed Last Stp+32
6. Most, not all notes was copied.
I am not 100% sure. It could have been that I did it in this order
1. I created a drum pattern with in bar 16 as Poly. Regretted my design and wanted to go for longer Mono pattern.
2. Pressed Copy+16
4. Pressed Paste+32
5. Pressed Last Stp+32
6. changed to Mono.
7. Most, not all notes was copied.
Anyhow, copy paste of the bars seem to not work in this state I ended up in, so I might have to clear the complete pattern and start from beginning again.
Maybe something to look into :) or if I'm doing something wrong.