Arturia Forums

Software Instruments => Buchla Easel V => Buchla Easel V - Technical Issues => Topic started by: PacificState on March 15, 2020, 04:56:11 pm

Title: Square Attack patch + phantom modulation oscillator frequency
Post by: PacificState on March 15, 2020, 04:56:11 pm

I feel a bit stupid posting this, but I've just started using the Easel and am having a problem:

If I load the Square Attack patch and change the gate settings so I can only hear the modulation oscillator, it's pretty clear that its frequency is being modulated by a sine wave; however, this continues after pulling *all* the patch cords and turning all the sliders down, which should leave it at a constant frequency. I can't figure out where this modulation is coming from - what am I missing?

Title: Re: Square Attack patch + phantom modulation oscillator frequency
Post by: LBH on March 15, 2020, 05:26:34 pm

Hi and welcome to Arturia forums.

You are welcome to ask.

My guess is, you are talking about the 5 modulations that's set in the LEFT HAND section in the extended view.  (Click the button with two arrows in the top right of the applications to get into extended views of Arturias applications.)

Title: Re: Square Attack patch + phantom modulation oscillator frequency
Post by: PacificState on March 15, 2020, 08:41:48 pm

I'm a doofus - that's it, thanks!

Title: Re: Square Attack patch + phantom modulation oscillator frequency
Post by: LBH on March 16, 2020, 12:20:04 am

Your welcome.