Arturia Forums

Hardware Instruments => MatrixBrute => MatrixBrute - General discussions => Topic started by: aWc on February 14, 2019, 06:25:44 pm

Title: patch names
Post by: aWc on February 14, 2019, 06:25:44 pm

I am entering patch names for my new patches using Midi Control Center, of course. However, I have not figured out how to insert spaces. A lot of factory patches have them, but is there a way to do it in MCC? Am, I missing something obvious or is it just not possible? Dr Justice has to know that for sure ;)

Title: Re: patch names
Post by: DrJustice on February 14, 2019, 06:59:38 pm

Spaces can't be entered in the MCC, unfortunately - I use the good old underscore as a substitute.

My guess is that the factory patches were specially created/named/prepared/imported, outside the normal end user process.