Arturia Forums

Hardware Sequencers => KeyStep => Keystep Technical questions => Topic started by: looneyprog on December 29, 2018, 08:12:02 pm

Title: Asigning Mod Wheel to Analog Lab's Cuttoff Control
Post by: looneyprog on December 29, 2018, 08:12:02 pm

Is it possible to assign Keylab's Mod Wheel to the Cuttoff knob control in Analog Lab?

I read in Keytep's Manual:
"10.9.2.13
Mod strip CC
Ordinarily a mod wheel is assigned to MIDI CC #1. But this parameter allows you to set
it to a different MIDI CC number so you can use it as an alternate modulation source"

I'm afraid I'm not advanced enough to know how to do this in the Control Center. Any help will be welcomed!