Arturia Forums
Audio => AudioFuse => AudioFuse - General discussions => Topic started by: cmackg on September 01, 2018, 12:32:26 am
-
I have this idea that I can set up a mix so that only the input 3/4 show up at say, Cue 1, and I have monitor that sound separate from the sound of stuff coming in through inputs 1/2 (say those are in the main mix). Ideally, perfect world, I could have 1/2 in cue 1, 3/4 in cue 2, and then all 4 in main. Like busses on a mixer.
I've tried a few times with the knobs, and don't see anything in the manual that makes this clear.
Am I missing something?
-
Hi, When using the AF in standalone with direct monitoring there is only 1 bus the inputs can go down both cue1 and cue2 on on the same mix bus so you will hear the same mix in each headphones .
but if used with you DAW you can set up separate mixes and use both phone independently for cue mixing as the cue channels have there own stereo inputs back in to the AF.
I can't see how its possible with direct monitoring/ standalone
Hope this helps
-
That makes no sense. If the hardware has the cue switches, it is changing routing, but we have no way to access that.
-
Huge bump I do apologise!
Did this get answered, I am seriously considering an audiofuse but can't see in the manual or any online review how the different cue mixes work. As the OP asked, I would hope that in the control centre software I can set up different mixes of the inputs for main/cue1 and cue 2 and then route them to the different output. Is this how it works?
Also are all these three mixes available in standalone mode? or just the main mix?
Thx