Arturia Forums
Hardware Sequencers => BeatStep Pro => BeatStep Pro - Technical Issues => Topic started by: Arndt on April 11, 2018, 08:44:06 pm
-
Hello everybody, I got my Beatstep Pro recently. After a firmware update (now 2.0.1.0) and a reset, the following step note input problem occurred:
until the firmware update the procedure was : holding a step + pressing a pad = note is assigned to that step, and the step was NOT muted (if I remember it right).
Now, when doing the same thing, the note is assigned to the step as before, BUT the step is MUTED and I have to unmute it.
Can please somebody confirm, that the steps are actually MUTED when notes are assigned to steps in the above described way? Or have I missed some special setting here,
which maybe was active before my last update? It worked so well for me before :-\
The other way round also works though (hold the pad and then press the step) but in that case the sound is triggered a bit longer, which I would like to avoid.
Thanks a lot.
-
Hi Arndt,
Yes, you are right. The behavior is a different.
Only way I see is doing Pad + Step instead of Step + Pad.
The other way round also works though (hold the pad and then press the step) but in that case the sound is triggered a bit longer, which I would like to avoid.
Yes, sorry about that.
Regards,
Y.
-
Hi Arndt,
Try this firmware:
https://drive.google.com/open?id=1_2BOKcHQAckYov2EX3zXiuGaHW8qJTs1 (https://drive.google.com/open?id=1_2BOKcHQAckYov2EX3zXiuGaHW8qJTs1)
Regards,
Y.
-
Thank you very much, I will try that the coming days. Will report the result.
-
Tried it now, and it works well again, just like it should, no muting when not wanted. Thanks for quick response.