Arturia Forums

Controllers => KeyLab Essential => KeyLab Essential - Technical Issues => Topic started by: d3llio on March 23, 2018, 06:58:45 am

Title: First encoder knob loose, automation is "jumpy"
Post by: d3llio on March 23, 2018, 06:58:45 am

I have a Keylab 49, and recently noticed that the first automation encoder knob was jumping around in Analog Lab. After pulling off the knob, I noticed a looseness when wiggling the knob that isn't present on the other knobs. Is there any recommended way to fix or remedy this problem? Thanks!

Title: Re: First encoder knob loose, automation is "jumpy"
Post by: Matt Arturia on March 23, 2018, 09:46:31 am

Hi,

If the issue is an hardware defect the best way to get a proper troubleshoot is to conctact our support services. They will get back to you quickly : https://www.arturia.com/support/askforhelp

Is the knob jumpy when you are turning it very slowly or does it behave like this in every situation ?

Regards,

Matthieu

Title: Re: First encoder knob loose, automation is "jumpy"
Post by: d3llio on March 23, 2018, 05:16:37 pm

Thank you for the referral!
It seems jumpy no matter what speed I turn the knob at, but if I apply some directional pressure while turning it, it seems to be a little smoother which makes me think that there is something wrong with the small metal rod underneath the knob, or possibly the  connection to the keyboard from the knob. Thanks again!