Arturia Forums

Controllers => MiniLab MKII => MiniLab MKII Technical Issues => Topic started by: Veldkoning on February 22, 2018, 01:32:22 am

Title: MiniLab mk2 knobs inside Analog LAB 3
Post by: Veldkoning on February 22, 2018, 01:32:22 am

Hello,

I just bought a MINILAB mk2 on the second hand market a couple of days ago because I needed a small midi controller for using my Analog LAB3 software which I purchased in this January. All the knobs are working as seen in the midi console inside the midi control centre, but when I am using Analog lab 3 the knobs 10-11 and 13 are not working. I know there are a lot of issues about 'jumping knobs' but these knobs are not doing anything. My firmware is 1.0.9.83 and for Analog LAB3 3.0.2.1289. Is this a common issue? Should I return this model and buy a new one?
(I am using macOS 10.13.3)

Title: Re: MiniLab mk2 knobs inside Analog LAB 3
Post by: Veldkoning on February 24, 2018, 12:53:03 am

Nobody?

Title: Re: MiniLab mk2 knobs inside Analog LAB 3
Post by: Veldkoning on February 28, 2018, 11:35:36 pm

It has been fixed, by uninstalling and reinstalling Analog LAB