Arturia Forums

Hardware Instruments => MicroBrute => Topic started by: lukitt on October 28, 2017, 11:48:29 pm

Title: MB & KP3Plus
Post by: lukitt on October 28, 2017, 11:48:29 pm

HI everybody,

excuse for my English...

I've a Microbrute SE and a KaossPad 3 Plus.
 
After upgrading MB, midi sync doesn't work. KP was the master and MB was the slave. Now when I set sync as EXT, the led goes off and nothing plays after recording the sequence.

Title: Re: MB & KP3Plus
Post by: lukitt on October 29, 2017, 08:14:45 pm

UPDATE: when I record the session and switch to play, nothing sounds. But If I play one note, it sounds only the note in hold.

What a mess!!!

Title: Re: MB & KP3Plus
Post by: lukitt on October 30, 2017, 10:04:44 am

UPDATE 2: I've tried with other devices but there's a problem in the midi-communication after the upgrade. I even tried to change midi-cable.
in effect when I switch Sync in EXT, sequencer doesn't work. If I switch in AUTO it's the same that I choose INTERNAL clock.

If it's possibile, I would the old firmware..PLease...i cannot work in this condition...

Title: Re: MB & KP3Plus
Post by: lukitt on November 02, 2017, 01:49:26 pm

Is it possibile that there is no answer in 5 days?

Whatever, does someone know to install old firmware?