Arturia Forums

Hardware Instruments => MatrixBrute => MatrixBrute - Feature requests => Topic started by: tp on August 01, 2017, 10:50:22 pm

Title: Set effects wet/dry independently for two filter outputs
Post by: tp on August 01, 2017, 10:50:22 pm

I don't know if this is plausible, but it would be great if you could apply the effects to the output of the two filters independently. This would be especially useful in Duo/Split mode. I could imagine it being implemented so that you hold the filter's assignment button while turning the Effects wet/dry knob in order to change the setting for that filter; the wet/dry knob by itself could function as it does now.

Title: Re: Set effects wet/dry independently for two filter outputs
Post by: joeman on August 03, 2017, 05:17:59 am

I like it. It would be a good feature.

Title: Re: Set effects wet/dry independently for two filter outputs
Post by: Vic-tor on August 03, 2017, 09:44:03 am

Hi !

While I agree it could have been a good feature, this is not permitted by the internal routing of the machine.

As far as I know the effects are at the very end of the signal chain, just before the master output (as hinted by their location on the synth panel)

It is the same as it you would plug a delay pedal after your guitar, the pedal has only one input and there is no way to decide which microphone goes into this input or not

Title: Re: Set effects wet/dry independently for two filter outputs
Post by: tp on August 16, 2017, 03:55:54 pm

Ah, thanks for the explanation. I thought that might be the case.