Arturia Forums

Hardware Sequencers => BeatStep Pro => BeatStep Pro - Technical Issues => Topic started by: Karlchen on July 14, 2017, 11:08:05 pm

Title: Settings of user project not uploaded to device project?
Post by: Karlchen on July 14, 2017, 11:08:05 pm

Hi there. I have a problem when trying to create a controller map in the BSP:

What I do:
- Assign different keys to the 16 pads in the tab "ControllerMap", e.g. the upper left pad gets "C0".
- Save this as user project
- Then upload this user project to the device slot "project 1" on the device, using drag&drop. The MCC shows "sending configuration to the device" and a progress bar.
- When I select Project 01 from the device and use the MIDI console in the MCC, the upper left pad sends "G#1", as if my changes have not been saved at all.

--> Did I miss a point? I'm using firmware version 2.0.0.2 and MCC 1.7.0.217.

Title: Re: Settings of user project not uploaded to device project?
Post by: I grec on July 18, 2017, 12:44:15 pm

Hi Karlchen,
Just tried from my side and it works.

• Be sure to save your user project before drag and drop
• A tip: You can drag and drop the whole project or just the ControllerMap (this last one is faster)
• Be sure the BSP is stopped or paused for the transfer to actually start when you use drag and drop

Do not hesitate to tell me if it still does not work.

Best,
Y.