Arturia Forums

Hardware Instruments => MatrixBrute => MatrixBrute - Technical Issues => Topic started by: Kearley on April 25, 2017, 08:16:59 am

Title: Editing Values in Seq or Arp Seq
Post by: Kearley on April 25, 2017, 08:16:59 am

Before this current firmware, I'm sure I was able to hold down a given step and use the 'mod amount' knob to edit it's value.

If it was a note value, it showed the note name... if it was a mod step, it had the value between -99 and +99.

Now, holding the step down and moving the knob has no actual effect.  I do see the seq display alternately showing +0 and -0 I think, but this doesn't seem right.

Did this change? Did I forgot how to operate?

D

Title: Re: Editing Values in Seq or Arp Seq
Post by: DrJustice on April 25, 2017, 02:41:45 pm

No you didn't forget anything, it's a bug in firmware 1.1.0.73. You can get it to work again by entering end exiting real time recording mode (press Record + Play to enter rt rec mode). The Mod Amount lock up may come back later, and you can again enter and exit real time rec mode to clear it up.

Title: Re: Editing Values in Seq or Arp Seq
Post by: yeskeys on July 09, 2017, 10:29:08 pm

I'm on 1.1.0.73 and I have never been able to touch a step in the sequencer and have it display the note associated with the step.  I hope they fix this.

I can however hold down the step and play a note on the keyboard, and the sequencer accepts that note for the step.  This works both while the sequencer is playing as well as when it is parked - with the Record button off.

Hope this helps someone.  Especially whoever is working on this issue!