Arturia Forums

Hardware Instruments => MatrixBrute => MatrixBrute - General discussions => Topic started by: Friendlynoise on March 15, 2017, 09:54:28 pm

Title: Use of phase knob on LFO1
Post by: Friendlynoise on March 15, 2017, 09:54:28 pm

Hi,

What is the phase knob on LFO 1 good for? I understand the theory, but I don't see how to apply musically this parameter. Any hints on how to use the phase knob? Any factory presets where the phase knob is sonically noticeable when tweking it?

Thanks for your help!

Title: Re: Use of phase knob on LFO1
Post by: DrJustice on March 15, 2017, 10:09:32 pm

For the phase to be controllable you must have the LFO in one of its Retrig modes or in Sync mode. Since it allows you to decide where in the cycle the waveforms start, it has many uses for anything from subtle modulation (e.g. a sound with vibrato starting sharp or flat) to extreme effects (let your imagination run wild).

Title: Re: Use of phase knob on LFO1
Post by: Friendlynoise on March 15, 2017, 11:07:09 pm

Hi,

Thanks for your hints. I was most using LFO1 in free mode. I'll try the other modes too.  :D