Arturia Forums

Hardware Sequencers => BeatStep Pro => Topic started by: NeoTokyo on February 15, 2017, 03:31:15 am

Title: How would you hook a Moog Werkstatt 01 to a BeatStep pro
Post by: NeoTokyo on February 15, 2017, 03:31:15 am

And is the gate out act as a gate in/out? I have a photo how someone did on Facebook! But it's to large to post.'and when I got to midi center and change to to cv5 will it really fry the board?

Title: Re: How would you hook a Moog Werkstatt 01 to a BeatStep pro
Post by: yield27 on March 24, 2017, 07:38:04 pm

Use something like these to lower the voltage you send to 5v and below. I just tried them a bit last night and the voltage levels were right where I wanted them and the werkstatt was happy.
http://www.ebay.com/itm/351678321723?_trksid=p2060353.m1438.l2649&ssPageName=STRK%3AMEBIDX%3AIT