Arturia Forums
Software Instruments => ARP2600 V3 => ARP2600 V3 - Technical Issues => Topic started by: jeffbart on June 18, 2016, 06:16:13 am
-
2 issues:
1) The manual section 4.1.13 'Reverberation' refers to 6 items - and the image 'The reverb module' shows only 2 of them.
The other items are 'Mixer' items, but this is not mentioned in the section heading.
2) There is a jack with no label at all. It's not explained in '4.1.13', even though it *is* in the manual image 'The reverb module'.
It's the reverb output.
Perhaps 'reverb out' could be a) added to the manual, and b) labelled on the front panel.
Cheers Jeff
-
2 issues:
1) The manual section 4.1.13 'Reverberation' refers to 6 items - and the image 'The reverb module' shows only 2 of them.
The other items are 'Mixer' items, but this is not mentioned in the section heading.
2) There is a jack with no label at all. It's not explained in '4.1.13', even though it *is* in the manual image 'The reverb module'.
It's the reverb output.
Perhaps 'reverb out' could be a) added to the manual, and b) labelled on the front panel.
Cheers Jeff
I've just been playing around with this Jack output and the level is much stronger on the right channel. It sounds like a feedback loop.
I don't see any use for it apart from blowing up your eardrums or speakers.
There's gotta be something wrong there, on the V2 version the output is the same level on the left channel and right channel, on the v3 the level is higher on the right channel.
I'd be interested in knowing what people use this for..