Arturia Forums
Hardware Instruments => MicroBrute => MicroBrute - General discussion => Topic started by: johnp352 on March 15, 2016, 06:56:55 pm
-
I have my MB connected to a Volca bass. VB is midi in from Ableton, MB is midi out through USB/Ableton. the MB pitch wheel is set to +- 12 steps. but the volca only responds to 2 steps..anybody ?
-
The +/-12 steps setting is only for the Microbrute's internal response to the wheel. The Microbrute always sends the full MIDI CC value range (0-127) over MIDI. You'll have to set up the Volca Bass to respond to the MIDI messages the way you want it to. Look in the Volca manual if there's a setting for the pitch bend range.