Arturia Forums

Hardware Sequencers => BeatStep Pro => BeatStep Pro - Technical Issues => Topic started by: djd_oz on February 10, 2016, 11:24:13 am

Title: (SOLVED) Not sending gate off when playing chromatic pads
Post by: djd_oz on February 10, 2016, 11:24:13 am

I've noticed that when playing the chromatic pads, the BSP is not sending gate off and remains on. Hence, the note sustains.

Any idea on how this can be fixed?

Title: Re: Not sending gate off when playing chromatic pads
Post by: smutek on February 14, 2016, 12:29:45 pm

What are you triggering with your BSP?

I've noticed some of the instruments from the Arturia V Collection do this, but I haven't had this problem with other synths or external gear. 

Title: Re: Not sending gate off when playing chromatic pads
Post by: kmeyerpdx on February 19, 2016, 08:50:39 pm

This started happening to me last night as well - but only on sequencer 2. After I power the unit on, pressing any chromatic pad on sequencer two will result in the gate being stuck high or on. It's not related to S-trig vs. V-trig, because S-trig results in the same behavior, the gate is permanently set to low/off. Has anyone found a solution?

Title: Re: Not sending gate off when playing chromatic pads
Post by: djd_oz on February 20, 2016, 10:13:40 am

I'm triggering eurorack modular modules, envelopes in particular ... seems to only happen to sequencer 2.

Title: Re: Not sending gate off when playing chromatic pads
Post by: Nagasaki45 on June 05, 2017, 02:07:31 am

I have the same issue: Gate on Sequencer 2 is stuck on high after pressing the pads.
I tried to power the BSP both from PC / adapter, thought it might be related, but the issue persist.
Note that after hitting the stop button it gate goes back to low / off, even if the device was stopped all of the time. In addition, Sequencer 1 works fine.

- Is it a know issue with the BSP?
- Otherwise, is my device faulty?
- I'm not sure what firmware I have. Do you think that software update will solve it?

Thanks!
Tom

Title: Re: Not sending gate off when playing chromatic pads
Post by: Edouard_Arturia on June 27, 2017, 03:19:37 pm

Hello.

Update your firmware should fix this issue.

You can do it from the Midi Control Center.

If the issue persists, simply hard reset your unit and try again, and it should work.

https://www.arturia.com/faq/utilization/how-to-hard-reset-my-beatstep-pro

Best Regards.

Edouard

Title: Re: Not sending gate off when playing chromatic pads
Post by: Nagasaki45 on July 01, 2017, 12:07:25 pm

Upgrading the firmware solved the issue.
Thanks Edouard!