Arturia Forums

Hardware Instruments => MicroBrute => Topic started by: JiggyWig on January 26, 2016, 10:02:26 pm

Title: Signal below 12 o'clock
Post by: JiggyWig on January 26, 2016, 10:02:26 pm

My microbrute gives no signal from any of the waveforms until turned past the 12 o'clock centre position. Is this expected behaviour? I ask because it seems odd.

Title: Re: Signal below 12 o'clock
Post by: Bacon on January 27, 2016, 04:52:59 pm

Definitely not expected behavior. You should get a signal through virtually all of the knobs' travel, and past the 12 o' clock position the oscillator output should start to overdrive the filter.

Title: Re: Signal below 12 o'clock
Post by: JiggyWig on January 28, 2016, 12:43:05 am

Thanks. I've just rechecked this just now, and I am getting output again. I'm going to keep an eye on this.

Title: Re: Signal below 12 o'clock
Post by: JiggyWig on January 28, 2016, 01:05:25 am

Okay, so it turns out I'm an idiot; I had left a noise gate in one of the signal chains with the threshhold set a little too aggressively (I'm getting quite a lot of noise in my signal at the moment for some reason).

Live and learn....