Arturia Forums

Hardware Sequencers => BeatStep Pro => BeatStep Pro - Technical Issues => Topic started by: GnomeFoam on January 16, 2016, 01:39:28 am

Title: MCC saying BSP is unplugged (Windows 7)
Post by: GnomeFoam on January 16, 2016, 01:39:28 am

Hi there,

I'm trying to update the firmware on my BSP, to no avail.

Whenever I plug in and turn on the BSP, it says it's unplugged - and if I try to update the firmware, it  says firmware download complete, please turn off and on again, however, when I do this, it then says "Failed to open the device. Please verify the device is not in use by another application".

The BSP is showing up in the device manager.

I've seen several threads about this but none concerning Windows.

Has anyone had this problem and found a cure?

Thanks in advance.

Title: Re: MCC saying BSP is unplugged (Windows 7)
Post by: GnomeFoam on February 02, 2016, 02:49:14 pm

No one?

Title: Re: MCC saying BSP is unplugged (Windows 7)
Post by: Terrym on February 02, 2016, 03:28:10 pm

Are you the same guy on fb with this problem.