Arturia Forums
Hardware Sequencers => BeatStep Pro => BeatStep Pro - Technical Issues => Topic started by: jrnmv on December 29, 2015, 08:13:32 am
-
In this example, I copied Seq 2 to Seq 1 (both 1 bar only), saved both. Shifting pattern on Seq 2 works fine, alternate, different note lengths, blah blah.
The bug is on Seq 1. Try shifting pattern backwards, forwards, sideways, whatever. It will revert back to its normal state (1/16, forwards) after 1 bar is complete, even though it's not supposed to.
In other words, if you shift note length, change it's direction, etc, on, say, step 4 (1 bar pattern in this example), when it starts over at step 1, it reverts back to playing forwards at 1/16, even thought you didn't change it back to that state.
Maybe this has been mentioned but frankly I'm too lazy to search.
-
I reckon you would have mentioned it if it was, but the patterns weren't chained were they? When a chain is played, all the patterns revert to their saved state each pattern change and repetition.
-
hey hey - no chain on this one. def a bug me thinks
-
Hmmm, might have to see it it happens to me too. I use non-4/4 patterns a lot and haven't noticed the de-sync since the first firmware. It was fixed with one of the firmware updates, or so I thought. Then again, I use lots of delay so it could have been disguised by that.
-
yeah if you have the time, it might be worth confirming.
and to replicate the behavior, get a 1 bar pattern going on Seq 2, then be sure to copy Seq 2 to Seq 1 first, save both.
i'm going to see if this is a larger issue than just 1 bar with seq 1 today...i'll report back.