Arturia Forums

Hardware Sequencers => BeatStep Pro => Topic started by: tlec on December 11, 2015, 12:45:41 am

Title: Can't use BSP's step sequencer in DAW (Cubase 8)?
Post by: tlec on December 11, 2015, 12:45:41 am

Just got my BSP so still getting the initial set up going.

Got it connected via USB into Cubase 8, Which it is detecting correctly on the midi channel, and when the BSP is in USB mode it's tempo slaves to the DAW as it should. but the step sequencer will not play when in USB mode?

I can only get the step sequencer to play when in INT (internal) mode?

Please help, I've already sifted through the manual for answers to no success.

Title: Re: Can't use BSP's step sequencer in DAW (Cubase 8)?
Post by: paulogic on December 22, 2015, 09:10:24 pm

Did you put the BSP in play mode ? (Just Press Play button and start Cubase).
Works fine here. Just got the BSP yesterday and it is performing as expected.

This may help : https://www.youtube.com/watch?v=OHODr7AKdic

Success,

Paulogic

Title: Re: Can't use BSP's step sequencer in DAW (Cubase 8)?
Post by: tlec on December 22, 2015, 09:37:59 pm

Its not that simple. Apparently there are quite a bit of steps you have to set up first in Cubase, I found out after Arturia finally sent me this manual. I've yet to try it, but I am sure this is where my issues lies.

These manuals should be made available on their website.

https://drive.google.com/open?id=0B-1e9zXr5JIlamltb2g4dnBDUzA

Title: Re: Can't use BSP's step sequencer in DAW (Cubase 8)?
Post by: paulogic on December 23, 2015, 12:11:42 pm

Sorry if I made it look simple...

Nice manual. I knew this because I also sync to other devices (SUB37, DarkTime)...

good luck !