Arturia Forums

Hardware Sequencers => BeatStep Pro => Topic started by: Martz on December 08, 2015, 11:42:01 am

Title: Print-out overlay templates for the BSP?
Post by: Martz on December 08, 2015, 11:42:01 am

Hi folks,

I'll soon start using my BSP to control a heck of parameters (Moog Sub Phatty Shift Functions, DAW stuff, etc), with no intention of memorizing them all. Thus, I wonder if there are any overlay templates around, that one would just need to label, print & cut out?

I couldn't find any yet. Any suggestions?

Cheers,
Martz.

Title: Re: Print-out overlay templates for the BSP?
Post by: megamarkd on December 09, 2015, 07:49:40 am

I've been tempted use white electrician's tape like I have on my mixer.  As long as it doesn't get too hot, it'll peel-off easily without leaving behind any gum.

Title: Re: Print-out overlay templates for the BSP?
Post by: Martz on December 09, 2015, 09:04:33 am

@megamarkd

That sounds like a reasonable way to go if it is one set of parameters to control. It doesn't work out though if it's several different sets..

Maybe I'll just do a template next year and upload to the media section.

Title: Re: Print-out overlay templates for the BSP?
Post by: megamarkd on December 09, 2015, 09:40:53 am

Yeah it's fine if you aren't going to change control maps.

Title: Re: Print-out overlay templates for the BSP?
Post by: DJRickDawson on December 10, 2015, 01:06:36 pm

interested too.

Title: Re: Print-out overlay templates for the BSP?
Post by: Taktility on November 17, 2016, 10:10:36 pm

Hi,
In case you are looking for exchangeable blank overlays ("scribble pads") for the Arturia Beatstep Pro, you can find them on my website www.taktility.com (http://www.taktility.com)
They are made of thin, flexible Polyester-based material (waterproof and non-tearable), are easy to write on manually and perfectly fit the device. The cut-outs for buttons and encoders also keep it in position, so no need for extra tape.

Title: Re: Print-out overlay templates for the BSP?
Post by: dog01 on November 20, 2016, 04:53:03 am

Takitility do you ship internationally and is there a list of country that you don't support also your site is down when ever i have tried to go on it

regards dog01 

Title: Re: Print-out overlay templates for the BSP?
Post by: Taktility on November 21, 2016, 12:26:58 am

Yes, I do ship internationally. Where are you based? Apologies if you encountered problems when accessing my site - I was not aware of any issue there. It might have been an issue with the link in my post in this forum, I hope I have fixed it now. Please drop me an e-mail at contact@taktility.com if the problem persists. Many thanks.