Arturia Forums

Hardware Sequencers => BeatStep Pro => Topic started by: Boytec on December 06, 2015, 11:35:09 am

Title: Beatstep Pro with Microbrute
Post by: Boytec on December 06, 2015, 11:35:09 am

Hello
I am trying to connect my microbrute to the green channel of my beatstep pro via CV/Gate (Gate out to gate in on microbrute and pitch out to pitch in on the modmatrix. Problem is the pitches from the microbrute is too high and I can not get any basetones. Am I doing something wrong?
thanx

Title: Re: Beatstep Pro with Microbrute
Post by: StutzJr on December 06, 2015, 08:41:01 pm

Hi, I haven't done any cv stuff with my bsp yet but apparently it's quite possible to adjust the voltage level of the base note C0 in the MCC program.  See the answer to the second question in the link here:
https://www.arturia.com/faq/utilization/beatstep-pro-general-questions (https://www.arturia.com/faq/utilization/beatstep-pro-general-questions)

Title: Re: Beatstep Pro with Microbrute
Post by: Martz on December 09, 2015, 09:21:13 am

Elsewhere, I read that turning off and on the synth while staying connected helped. Haven't tried it yet, though.

Title: Re: Beatstep Pro with Microbrute
Post by: Valentin Arturia on December 09, 2015, 10:55:53 am

Hi,
Check the Arturia FAQ link (the one posted by StutzJr) and have a look to the part "Why my Micro/MiniBrute play higher when connected in CV/Gate to my BeatStepPro ?"