Arturia Forums
Hardware Sequencers => BeatStep Pro => Beatstep Pro - General Discussions => Topic started by: moor hertz on December 02, 2015, 07:50:10 pm
-
Hi all,
Another gremlin has come up, sequence 2 no longer shows the little dot in the LCD display to indicate the sequence has been edited, sequence 1 and the drum channels are fine.
I have reset the firmware, and used the default template in the midi control centre, to no avail.
Best
Adam
-
Hi all,
Another gremlin has come up, sequence 2 no longer shows the little dot in the LCD display to indicate the sequence has been edited, sequence 1 and the drum channels are fine.
I have reset the firmware, and used the default template in the midi control centre, to no avail.
Best
Adam
Here is a quick video I made to demonstrate the issue>>>>Not sure if the unit is faulty, or the firmware, either way, it is a little frustrating!
https://www.youtube.com/watch?v=IgOkUsj9qoE&feature=youtu.be (https://www.youtube.com/watch?v=IgOkUsj9qoE&feature=youtu.be)
-
Hi,
Strange behavior. Try to clear all sequences on Seq2 and then re load the Firmware.
-
Hi,
Strange behavior. Try to clear all sequences on Seq2 and then re load the Firmware.
Very strange indeed!
I tried reloading the firmware after clearing the sequence, several times, and it failed to remedy the issue.
I have sent it back to the company I bought it from now as I gave up trying to sort the issue.
Looking foward to getting a fully working unit back, when it did work, it was perfect for my setup!