Arturia Forums

Hardware Sequencers => BeatStep Pro => BeatStep Pro - Technical Issues => Topic started by: Soul_Processor on November 30, 2015, 09:44:35 am

Title: Sequencer / Keyboard will only go down to C0
Post by: Soul_Processor on November 30, 2015, 09:44:35 am

Hi,

I updated the firmware yesterday, and all of a sudden, I can't go any lower with the keyboard and both sequencers than C0, even though I set the lowest note for both seqs to C-2 in the midi control center. I also sent the settings to the working memory of the device, but nothing changed. this is quite annoying because I can't use it to write basslines now.

any ideas?

Title: Re: Sequencer / Keyboard will only go down to C0
Post by: Terrym on November 30, 2015, 10:33:34 pm

Hi ,for cv control you need to set the 0cv to say +1C or +2C to get lower notes



terrym

Title: Re: Sequencer / Keyboard will only go down to C0
Post by: Soul_Processor on December 01, 2015, 07:59:27 am

ah okay, I thought the 0V note would be the lowest one, I wasn't aware that CV goes down to negative voltages... will try that later.

but will the keyboard then also go down to the lower octave? because I had the same problem with seq2 which is sending MIDI to a PC, not CV...

thanks anyway, I'll report back if it worked out!