Arturia Forums

Harware Legacy versions => KeyLab => Topic started by: davidmolina on October 22, 2015, 05:22:18 am

Title: Pad Velocity Sensitivity Ridiculously Low
Post by: davidmolina on October 22, 2015, 05:22:18 am

I just purchased a Keylab 49 Black and I'm trying to set up the pads but their sensitivity is exremely low. In order to get some decent velocity out of them I have to hit them ridiculously hard and I feel I will break them, besides my fingers just hurting after 4 or 5 hits.

I've tried every Pad Velocity Curve in MIDI Control Center but they are all way too low or just a single very high velocity. I've read about several people having the same issue. Anyone know of a fix or setting? I have the latest firmware installed.

Title: Re: Pad Velocity Sensitivity Ridiculously Low
Post by: Jorgalad on October 23, 2015, 01:24:53 pm

I think it might be the latest firmware, for some reason my pads only send a max value of 110 velocity since the upgrade

Title: Re: Pad Velocity Sensitivity Ridiculously Low
Post by: davidmolina on October 26, 2015, 11:38:44 pm

Yes, that was it. Thanks! I just reverted back to v1.29 and it mostly corrected the issue. I still can't go past around velocity 120 but at least I've got much better response now. Hopefully they correct it soon!

Title: Re: Pad Velocity Sensitivity Ridiculously Low
Post by: Jorgalad on October 27, 2015, 08:28:25 am

Thanks for verifying, now I'm considering going back too. Although I changed most of my code already to work with this new system. I also noticed that using the keyboard to edit values (like velocity curves) often does a better job than the software editor.
So you could try that for the pads.