Arturia Forums

Hardware Sequencers => BeatStep Pro => Beatstep Pro - General Discussions => Topic started by: darknoiseattrator on August 28, 2015, 12:16:38 pm

Title: Midi Control Center Not Seeing BSP after Firmware Update
Post by: darknoiseattrator on August 28, 2015, 12:16:38 pm: I successfully updated my BDP to firmware 1.1.6, but afterwards, the Midid Control Center will not sync, displaying the message "Error. Device not found." I'm on an iMac running OS 10.9.5. Previously it was fine and I did not have this issue with the first BS. I have made sure that the BSP is not appearing as a device in Apple's Midi Setup.

Suggestions?
Title: Re: Midi Control Center Not Seeing BSP after Firmware Update
Post by: Terrym on August 28, 2015, 04:40:05 pm: Hi try going to audio midi setup app and deleting the beat step pro driver then plug the Bsp usb back into your computer see if that cures your problem

regards

terrym
Title: Re: Midi Control Center Not Seeing BSP after Firmware Update
Post by: darknoiseattrator on August 29, 2015, 08:47:50 pm: See the attached screenshot. The Audio Midi Setup does not have the BSP shown, but the Midid Control Center will still not see my BSP. As I said, I actually did do a firmware update, but immediately afterwards I could not sync.
Title: Re: Midi Control Center Not Seeing BSP after Firmware Update
Post by: floThePro on August 29, 2015, 11:55:51 pm: hmmm....
what does the BSP display say?
"UPD"????

I had to repeat and repeat and wait "longer".......then it works! ,-)
Title: Re: Midi Control Center Not Seeing BSP after Firmware Update
Post by: darknoiseattrator on August 30, 2015, 04:49:11 pm: Well, the update worked and installed. This is after the update and trying to sync with the Midi Control Center.
Title: Re: Midi Control Center Not Seeing BSP after Firmware Update
Post by: Terrym on August 30, 2015, 06:57:54 pm: Open up the audio midi setup page bigger it is there but hidden . then make sure the bsp is not connected and delete the driver and then reconnect .

Terrym