Arturia Forums

Hardware Sequencers => BeatStep Pro => Beatstep Pro - General Discussions => Topic started by: jrnmv on August 14, 2015, 05:50:44 am

Title: Custom Midi Notes in Drum Seq
Post by: jrnmv on August 14, 2015, 05:50:44 am

Apologies if this has already been covered somewhere on here, but I've been getting some really odd note values from the drum pads when custom mapping them.

So, values range from 36-84, which is C1-C5, right? I assume that these values can be lower or higher depending on the base transpose note set in the MCC.

In custom map mode, I enter the following values for steps 1-16:1)73, 2)50, 3)65, 4)49, 5)74, 6)48, 7)68, 8)42, 9)44, 10)54, 11)60, 12)59, 13)84, 14)49, 15)50, 16)51.

Store to project 1,close MCC, start sequence, and it plays (sequential order, from pads 1-16): 1)G#1, 2)F#2, 3)C3, 4)B2, 5)C5, 6)C#2, 7)D2, 8)D#2, 9)C#4, 10)D2, 11)F3, 12)C#2, 13)D4, 14)C2,15)G#3, 16)F#1

So I'm definitely missing something obvious here, right?  :-\