Arturia Forums

Hardware Sequencers => BeatStep Pro => BeatStep Pro - Technical Issues => Topic started by: RichMakeGame on July 30, 2015, 12:13:00 pm

Title: Looper bug
Post by: RichMakeGame on July 30, 2015, 12:13:00 pm

I was playing a sequence with swing and brushed against the looper and it went out of sync. If i fiddle with the looper some more it eventually corrects. I'm on current firmware

Heres a vid, hopefully its a known issue
https://m.youtube.com/watch?v=aHINjIG-jmI

Edit: just noticed this is listed as a previous issue: it's fine with no swing but otherwise still exists
Ps- tested from newly cleared patterns.

Title: Re: Looper bug
Post by: RichMakeGame on August 04, 2015, 03:48:20 pm

This bug persists in the new firmware.

Steps to reproduce: create a drum sequence, with simple kick/snare pattern, hi-hats on every step. turn up swing to max and play sequence. keep intermittantly touching the looper at various positions until you notice the swung hi-hats have turned into a 'gallop', ie steps are playing early instead of late

that's not all- I found the same bug when changing last step during playback. Keep changing between a 16 and 32 length pattern and eventually the gallop bug happens.

PS- where is the best place to post firmware bugs? here or via support ticket? I just want some acknowledgement that it's in the system and the programmers are aware

Title: Re: Looper bug
Post by: Valentin Arturia on August 05, 2015, 10:14:00 am

Hi RichMakeGame,

Thanks for reporting this. We know there's still some issues using the looper and it's in the system. :)

Title: Re: Looper bug
Post by: RichMakeGame on August 05, 2015, 02:19:58 pm

Thanks for letting me know :) apologies for panicking a bit :). It comes from liking the bsp a lot!  Please note though that i found the swing issue with pattern length changes too, not just the looper. Thanks again