Arturia Forums

Hardware Instruments => MicroBrute => Topic started by: hudson on July 27, 2015, 03:03:15 pm

Title: Brand new Microbrute SE sequencer stopped working
Post by: hudson on July 27, 2015, 03:03:15 pm

Anyone have this happen? When I enable play on the sequencer and press a note, nothing happens.  When I turn it off, the note returns. 

I just received this on Friday and it was working out of the box.

Title: Re: Brand new Microbrute SE sequencer stopped working
Post by: Vic-tor on July 28, 2015, 09:08:57 am

Hey !

Copy paste from another topic I answered, but most probably the issue in your case :

Like explained here: http://forum.arturia.com/index.php?topic=14320.0

The latest Microbrute firmware version sets the synth so that the sequencer only runs when it receives a gate signal to its Gate In input at the back.

To change this, download and install the Microbrute connection software if you have not already:

http://www.arturia.com/support/updates&manuals#microbrute

Launch it, and set the "Step On" parameter at top right to "Clk". This way, the sequencer will run on its own clock.

Also, make sure that the "Sync" parameter is not set to EXT, otherwise the sequencer will only start when it receives a MIDI start message.

Hope this helps ! :)