Arturia Forums

Hardware Sequencers => BeatStep Pro => BeatStep Pro - Technical Issues => Topic started by: maddyman on July 26, 2015, 03:25:38 pm

Title: This is a wish for the next updated firmware : a button combination for PANIC
Post by: maddyman on July 26, 2015, 03:25:38 pm

Just trying out the multiple settings with the BSP and sometimes it hangs. I can only save the project and have to turn the device off.

Would be nice to have a combination of buttons to get a "panic" command.

Title: Re: This is a wish for the next updated firmware : a button combination for PANIC
Post by: Zymos on July 26, 2015, 03:39:25 pm

It's already there (mentioned in the manual and everything)- hit the stop button 3x.

Title: Re: This is a wish for the next updated firmware : a button combination for PANIC
Post by: maddyman on July 26, 2015, 03:59:22 pm

It is written there that the target device might be hanging and therefore a all notes off command often help.
But in my case(s) the BSP is totally hanging and your advice is for the birds.  :-\
Anyhow - thank you for the reply

Title: Re: This is a wish for the next updated firmware : a button combination for PANIC
Post by: DarkStar679 on July 27, 2015, 01:52:31 pm

Had this yesterday. The BSP was frozen, almost all pads were light up and no reaction.
A power cut did help.

Title: Re: This is a wish for the next updated firmware : a button combination for PANIC
Post by: Valentin Arturia on July 27, 2015, 05:25:15 pm

Pressing 3 times stop will send an All Notes Off message on every MidiChannels and therefore  that's not a solution if the BSP is hanging.
"A power cut did help" and that's the solution.