Arturia Forums

DRUMS => Spark => Spark Technical Issues => Topic started by: sarasimms on September 02, 2014, 05:28:35 am

Title: Request for Help Setting Up Spark with Logic
Post by: sarasimms on September 02, 2014, 05:28:35 am

Hi Arturia Community,

I would like to set up Spark with Logic, but am having challenges getting the IAC Driver configured properly on my Mac.

In the IAC Driver Properties, the connector's for Spark's MIDI In and Out are greyed out. In Spark's preferences, under 'send MIDI to sequencer' the option that I've selected is YES but I am receiving the message '### would use IAC Driver Spark1 MIDI Out' but the port doesn't exist.

Could someone please help to provide advice on how to correctly set up Spark in the IAC Driver Properties? I need to get this working before this weekend.

Thank you!

Best wishes,

Sara Simms

Title: Re: Request for Help Setting Up Spark with Logic
Post by: Terrym on September 02, 2014, 08:35:51 pm

Hi sara, have spark 2 ? did you follow the instructions on page 101 of the manual .you must spell it correctly otherwise it will not work in the audio midi setup in the mac.(see below)


regards

terrym