Arturia Forums

DRUMS => Spark => Spark Technical Issues => Topic started by: jksuperstar on August 26, 2014, 05:07:18 pm

Title: Using SparkLE controller through midi router
Post by: jksuperstar on August 26, 2014, 05:07:18 pm

I have an iConnectivitymMIDI4+, and have the SparkLE connected to it.  I can see MIDI arriving in the PC, as it is routed from the sparkle through the CM4+ to the PC on it's own dedicated port.

However, Spark 2.0.1 does not find the controller, and I can not force it to use a specified port.

Am I missing this parameter in configuration, or is it indeed missing?  Can this be added?

Title: Re: Using SparkLE controller through midi router
Post by: Terrym on September 02, 2014, 08:46:48 pm

Hi are you using the sparkle on the usb port on the rear on the far left hand side ? is this powering up sparkle . i also think sparkle only works with a direct midi port to your pc .

regards

terrym

Title: Re: Using SparkLE controller through midi router
Post by: jksuperstar on September 04, 2014, 08:56:20 am

yes, it is the USB Host port.  It powers up the SparkLE fine (I use a powered hub with it).  The iCM4+ sees the device as "SparkLE", and I can see MIDI going through to the PC.

But selecting to "Connect Controller" in Spark software does not detect the controller (always results in "Failed to find Controller").