Arturia Forums

Harware Legacy versions => Analog Laboratory => Analog Laboratory Users Community => Topic started by: marsel on September 05, 2011, 11:49:51 am

Title: how to setup sequencer with logic studio
Post by: marsel on September 05, 2011, 11:49:51 am

probably this has been discussed on the forum already but i cannot find it, and the manual book does not seem to explain how to do it from the beginning...

i've installed the laboratory software and connected the keyboard, but i cannot figure out how to make the sequencer and controllers work in logic - in the learning mode it does not have arturia in the list. does it mean i need to somehow setup each control one by one? or is there a shortcut im missing? please help!

Title: Re: how to setup sequencer with logic studio
Post by: curtified on September 07, 2011, 10:37:17 pm

Im looking for answers too.

http://www.arturia.com/evolution/smf/index.php?topic=4651.0

posted that a while ago..

I have found a way to learn the midi controls using program called Midi Monitor to filter out all the bad midi data when I map controls.

Anyone else get this working?

Title: Re: how to setup sequencer with logic studio
Post by: Manuel on March 21, 2012, 01:22:42 pm

Try this Solutions! (http://www.arturia.com/evolution/smf/index.php?topic=5322.msg17507#msg17507)

Others reported that it would work this way also in other DAWs.
So give it a try and

don't forget to applaud for me if this tip was helpful for you!    ;)