Arturia Forums

V Collection - Legacy versions => Modular V => Modular V Technical Issues => Topic started by: YESMAN on November 09, 2009, 02:34:51 am

Title: patch cords
Post by: YESMAN on November 09, 2009, 02:34:51 am

Hello All,
  I have been checking out the MMV 2.5 demo. Sounds very nice, I am finding that as I modify (remove, add patch points) then save the program, choose a different sound and return to the first. Patch cables that I had removed are now showing up, remove again save.....same deal. Are others seeing this or ant ideas? This is happening stand alone and in Cubase Studio 4 as a VSTi. Running on a PC with XP.
  Thanks

Title: Re: patch cords
Post by: YESMAN on November 09, 2009, 02:41:22 am

Also, I have looked at the text file for the preset and it shows no connections between the points where these cables are showing up.

Title: Re: patch cords
Post by: Wookiee on November 11, 2009, 12:53:50 pm

Hi Yesman

I have reported a similar problem to Tech support and they have reported back that they are investigating this problem.

To quote from their reply

Quote

We are currently investigating this filthy behavior, and will get back to you asap.

What I am finding is a connection from the sine output of LFO2 to the first available mixer input, the output of this goes to the FM of Osc control 1, the mixer point concerned is also connected to the mod wheel output.  Is this what you are finding?

Title: Re: patch cords
Post by: YESMAN on November 11, 2009, 04:02:02 pm

Yes, that's what I see also. Good to know Artiria is looking at this, Thanks

Title: Re: patch cords
Post by: Antoine on November 12, 2009, 09:59:40 am

Yep, this is an automatic assignation from the Modulation Wheel, yet a bit intrusive.
This is being changed soon, we think about implementing a general option allowing "common automatic assignations" enabled by default (then switchable to "off"), instead of the actual forced mode.