Arturia Forums
V Collection - Legacy versions => Mini V => Mini V Technical Issues => Topic started by: JTorrance on June 11, 2009, 05:05:15 am
-
I'm running several instances of MiniMg V in a Logic environment that I use live as an Audio Units host on a Mac Mini. I'm sending it bank, sub-bank and program changes, in that order (I can see them getting to the unit on an environment monitor I have wired in there), but it's not changing the programs. It does appear to sometimes change the bank and sub-bank, but not select the program, and the name in the display doesn't change until I hit the "down program" button. I had a very similar environment running for Michael Brecker 3 or 4 years ago, and there was no need to send the bank/sub-bank, we just sent program changes and the MMV responded. I'd like to run all my Mg patches on a single instance because I find that, once I've played one of the instances, each subsequent one ups the processor usage until, by the time I've played 3 of them, it's permanently maxed out. I'm going to start another thread on that. Any ideas on getting the PG changes to work? Is it possible that, since the 2 controller messages and the PG change are all transmitted within a millisecond or two, that there's not enough time between them?
-
Did you try this Knowledge Base article (http://www.arturia.com/evolution/kb/?View=entry&EntryID=105)?