Arturia Forums

V Collection - Legacy versions => Modular V => Modular V Technical Issues => Topic started by: lkonrad on February 19, 2007, 01:08:15 am

Title: Automation Question
Post by: lkonrad on February 19, 2007, 01:08:15 am

Hi ,

I use Logic pro 7 and the Mg Modular V2.
I would like to automate The amount of a routing , for exemple , the amount of the modulation of the Cutoff filter by the sinus wave form an LFO for exemple. Physically , that means that i want to be able to record the movement of the little wheel where i plug the output of the sine waveform...

I don't find a way to do it ... This control is not present in the list of automationnable controls...
I sthere a special way , like patching some cable , to be able to do it?

Thanks a lot