Arturia Forums

Hardware Instruments => MicroBrute => MicroBrute Technical Questions - FAQ => Topic started by: Super Hydro on March 01, 2014, 11:56:57 pm

Title: Sequencer not working
Post by: Super Hydro on March 01, 2014, 11:56:57 pm

Hello everyone,
I have been using my micro brute for about 2 months now. I use the pattern option quite a but. For some reason today when I put the pattern to play and press a key nothing comes out. the green light for the note on doesn't even cone on. I went through the manual and changed settings in the software but it still will not note on when I set the pattern to play. any ideas?

thank you,

Title: Re: Sequencer not working
Post by: wackelpeter on March 02, 2014, 06:43:31 pm

is the mode (step on) in microbrute connection set to "clk" ?