Arturia Forums
Hardware Instruments => MicroBrute => MicroBrute Technical Questions - FAQ => Topic started by: funkatron on January 14, 2014, 04:12:19 pm
-
Hi I love this micro brute. I bought it because of the sequencer.
however the sequencer now has problems.
it will record, but only one sequence. meaning it will play back the same sequence on all 8 channels. no matter which channel it was recorded on.
I tried resetting factory sequences. but it still only plays the last sequence I recorded on all 8 channels.
Can you please help. thank you in advance.
-
if you reset patters to factory, using Connection software. when in play mode, can you access the 8 sequences with the knob?
-
No it will not load presets.
still only last sequence saved plays on all channels.
hope you can still help.
-
I meant, if you reset to factory patterns, can you play them? we will check recording later
-
no it will not play them.
-
it sounds like your pattern knob is faulty or has a bad solder joint. I think you will have to deal with your reseller.
-
or maybe a loose cable connection, but it's quiet unlikely to happen on a Microbrute. You can still give it a look
-
even after factory patterns are reloaded it still plays the last sequence I recorded. not a factory preset.
this machine is under warenty with arturia.
I would love to take it apart and look inside to see if I can see if there is a problem in there. but would that void my warrenty?
also tech support did not reply to my request, its been a week now. I sent them 2 requests.
at a loss of what to do hear.
if the machine is broken or faulty I would like to send it to arturia for repair.
-
not sure arturia will deal directly with you about the warranty. try to contact your reseller (thomann, shop, etc) in order to send them the unit back. i would not open it, as the warranty could be gone forever
-
thanks, good point. that is what I will do.
to bad because that sequencer is so nice.