Arturia Forums

Hardware Instruments => MicroFreak => MicroFreak - Technical Issues => Topic started by: stuzog on May 26, 2023, 09:37:40 pm

Title: Update 5 bricks Microfreak
Post by: stuzog on May 26, 2023, 09:37:40 pm

Update 5 was interrupted before completion on Mac M2 Air latest Ventura. Now stuck with only Utility light on and MIDI Control Center showing Device not connected in blank right-hand pane. Is there any way of getting out of this state? I note that nobody on this Forum has ever received a solution from Arturia on this. Is this MicroFreak now bricked forever?  ???

Title: Re: Update 5 bricks Microfreak
Post by: Guest on May 30, 2023, 06:59:05 pm

I am a Windows user but I resolved it by clicking in unknow firmware revision and start updating again. You can choose an old firmware file or try the new one again.

Title: Re: Update 5 bricks Microfreak
Post by: demotricus on May 30, 2023, 11:38:27 pm

Same kind of issue here. The update seemed ok until I cycled the power. When it powered up, all the patches had been wiped. (just showing 'init') & I was unable to transfer them within midi centre. I've managed to roll back to the previous firmware ( 4_0_3_1625 ). Hope they fix this, I was looking forward to the new sample and granular engines.