Arturia Forums
Hardware Instruments => PolyBrute => PolyBrute - Technical Issue => Topic started by: paulmapp8306 on March 11, 2023, 03:22:59 pm
-
so, new to polybrute. But I think I may have a fault, tried direct contact with Arturia but nothing yet.
The problems.
1. Polybrute always sends start/stop commands even if I have midi output destinations off, and Arp/Seq midi set off.
2. I never get seq or arp note data sent externally regardless if the arp/seq midi send is on or off.
Those 2 seem linked.... Its ALWAYS sending start/stop and NEVER sending note data.
3. Clock. Clock data is also sent out regardless of the arp/seq setting or if the out destination is off or not. It even sends it if I set its source to an external source. When set to internal, it sends it out and then receives it back (There is a midi clock loop - not a note loop as I can filter notes but not MTC currently). It means I cant use external sources as I just get that mess of timing as the clock keeps multiplying.
I thing this is also linked to the first 2.
My gut says that the Arp/Seq midi out toggle isnt working, and its doung kind of a halfway house thing - so clock and start/stop are always sent regardless - but noted data generated by either arpo or sequencer arnt sent out.
Obviously if theres a faut - I can get it replaced but need to confirm if this is, or isnt normal.
I have a new midi patch bay coming (as I no longer have enough ins and outs for home use - good for live) which does have clock and start/stop filtering - so Ill be fine down the line if its normal - bu i t doesnt seem right to me. Just need some clarification.